Getting Started
Rear Panel
| SPEAKERS OUT |
| |
|
|
| : 3 |
| FRONT R | FRONT L | IMPEDANCE |
|
| ||
SPEAKER OUTPUT | SUBWOOFER | CENTER |
|
|
|
| |
CONNECTORS |
| HDMI IN | |
COOLING FAN |
| ||
* In case of
AUX IN * FM ANTENNA
POWER
SURROUND R SURROUND L
FRONT R | FRONT L |
SUBWOOFER CENTER
SPEAKERS OUT
IMPEDANCE : 3
AUX IN | FM ANT |
LAN
L
|
|
| R | OPTICAL |
HDMI OUT | 1 | HDMI IN | 2 | DIGITAL |
AUDIO IN |
POWER CORD | HDMI OUT | LAN TERMINAL EXTERNAL DIGITAL |
|
| AUDIO IN (OPTICAL) |
*Connecting the FM Antenna
1.Connect the FM antenna supplied to the FM ANT Jack.
2.Slowly move the antenna wire around until you find a location where reception is good, then fasten it to a wall or other rigid surface.
NOTES
Maintain a minimum of 10 cm of clear space on all sides of the home cinema to ensure adequate ventilation. Do not obstruct the cooling fan or ventilation holes.
This product does not receive AM broadcasts.
Attaching the Toroidal Ferrite Core to the Power Cord of the Wireless
Receiver Module (SWA-6000)
* In case of HT-F6530W/F6550W
If you attach a Toroidal ferrite core to the power cord of the wireless receiver module, it will help to prevent RF interference from radio signals.
1.Pull the fixing tab of the Toroidal ferrite core to open it.
2.Make a loop twice in the wireless receiver module power cord.
3. Attach the Toroidal ferrite core to the wireless receiver module power cord as the figure shows and press it until it clicks.
•Insert the ferrite core as close to the Wireless Receiver Module as possible.