Settings
Remote
Support
When activated, lets Samsung Call Centre agents diagnose and fix problems with the product remotely. Requires an active Internet
1. | In the Home screen, select Settings, and then |
2. | press the E button. |
Select Network, and then press the E button. | |
3. | Select Network Settings, and then press the E |
| button. |
Management
connection. Remote Management service might not be available in some countries.
4. Go to the instructions for Wired networks starting |
below or the instructions for Wireless networks |
starting on page 27. |
Software
For more information about the
Wired Network
Update
Software Update function, see "Upgrading Software" on page 29.
Lets you set the Use mode. If you
❑Wired – Automatic
After following Steps 1 to 3 above:
Usage Mode
are using the home cinema at home, always select Home. Store is for retail display settings only.
1. In the Network Settings screen, change Network |
type to Wired. Then, select Connect and press |
the E button. The product detects the wired |
connection, verifies the network connection and |
Contact Provides contact information for
Samsung assistance with your product.
then connects to the network. |
2. When it is done, highlight OK, and then press E |
Reset
Reverts all settings to their defaults except for the network and Smart Hub settings, and then starts the Setup function. Requires that you enter your security PIN. The default security PIN is 0000
button. |
❑Wired - Manual
If you have a static IP address or the automatic procedure does not work, you'll need to set the Network Settings values manually.
After following Steps 1 to 3 above:
Networks and the Internet
When you connect this product to a network, you can use network based applications and functions such as Smart Hub and
Configuring Your Network Connection
If you didn't configure your network connection during the initial settings procedure or you need to reset the network connection, follow the directions below.
Before you begin, contact your Internet Service Provider to find out if your IP address is static or dynamic. If it
is dynamic, and you have a wired or wireless network, we recommend using the Automatic configuration procedures described below.
If you are connecting to a wired network, connect the product to your router using a LAN cable before you start the configuration procedure.
To begin configuring your network connection, follow these steps:
1.In the Network Settings screen, change Network type to Wired. Then, select Connect and press the E button.
The product searches for a network, and then displays the connection failed message.
NOTES
If it is possible to connect the home cinema to your network wirelessly, select Change Network at this point, change the Network type to Wireless, and then go to the instructions for wireless networks on page 27.
Network Settings
Wired network connection failed. | XX:XX:XX:XX:XX:XX | |||||
|
| MAC Address | ||||
|
| IP Address | 0. | 0. | 0. | 0 |
|
| Subnet Mask | 0. | 0. | 0. | 0 |
|
| Gateway | 0. | 0. | 0. | 0 |
|
| DNS Server | 0. | 0. | 0. | 0 |
Unable to connect to the network. Try the following: check if your IP address is set correctly in IP Settings. Contact your Internet service provider for more information.
Change Network | IP Settings | Retry | Close |
2.Use the ◄► buttons to select IP Settings, and then press the E button. The IP Settings screen appears.