To show the RDS signals
You can see the RDS signals the station sends on the display.
Press the RDS DISPLAY button while listening to an FM station.
~Each time you press the button, the display change
to show you the following information : PS NAME RT CT Frequency
-When pressing the buttons on the primary remote control, make sure that you have selected the FM station using the primary remote control.
RDS DISPLAY | TA | |
1 | 2 | 3 |
PTY - | PTY SEARCH | PTY + |
4 | 5 | 6 |
PS (Program
While searching, <PS NAME> appears and then the station
1. Press the PTY SEARCH button while listening |
to an FM station. |
Service)
names will be displayed.
<NO PS> appears if no signal is sent.
While searching, <RT> appears and then text messages the
2. Press the PTY- or PTY+ button until the PTY |
code you want appears on the display. |
~ The display gives you the PTY codes |
described to the right. |
RT (RadioText) station sends will be displayed. <NO RT> appears if no signal is sent.
3. Press the PTY SEARCH button again, while the |
PTY code selected in the previous step is still on |
the display. |
~ The centre unit searches 15 preset FM |
Frequency
Station frequency
stations, stops when it finds the one you have |
selected, and tunes in that station. |
About characters shown in the display
When the display shows PS,or RT signals,the following characters are used.
~The display window cannot differentiate upper case and lower case letters and always uses upper case letters.
~The display window cannot show accented letters, <A,> for instance, may stands for accented <A’s> like <À, Â, Ä, Á, Å and Ã.>
PTY (Program Type) indication and
One of the advantages of the RDS service is that you can locate a particular kind of program from the preset channels by specifying the PTY codes.
To search for a program using the PTY codes
~Before you start!
-The PTY Search is only applicable to preset stations.
-To stop searching any time during the process, press 5 button while searching.
-There is a time limit in doing the following steps. If the setting is cancelled before you finish, start from step 1 again.
Network Setup
When you connect this product to a network, you can use network based applications and functions such as
Configuring Your Network Connection
To begin configuring your network connection, follow these steps:
1.In the Home screen, select Settings, and then press the E button.
2.Select Network, and then press the E button.
3.Select Network Settings, and then press the E button.
4.Go to the instructions for Wired networks starting below or the instructions for Wireless networks on the right of next page.
22 - English