Samsung TC242W Thin Client Monitor TC242W 3.Normal Standby mode

2.4Sequence of events to reach the mode where the equipment automatically change modes ( It is necessary to write the taken time to reach to the mode )

N/A

2.5Any notes regarding the operation of the equipment

N/A

2.6 Instrumentation

Test instruments which were used in the test are as follows;

Test instrumentation		Model name	Manufacturer	Serial or Firmware		Calibration
				(No./Ver.)
						Date
Stopwatch		PC90	Time Art	TPST003		1st Apr. 2015
Power meter		WT1806	Yokogawa	0GAA-B04817	30th Mar. 2015
Power Source	61605		Chroma	0GAA-B05037	7th Oct. 2015

2.7 Measurement method used

-Measurement condition_1) Picture : no input load, 2) Sound : no input load.

-The EUT was placed into off mode using the hard switch

-The EUT was placed into the mode allowed to stabilize for 30 minutes.

-The stability is established where the power difference between the two comparison periods divided by the time difference of the mid-points of the comparison periods has a slope of less than 10 mW/h.

-The accumulated power consumption was measured for 10 minute.

2.8Set-up and circuit for electrical testing ( Insert the picture or diagram of the test configuration )

3.Normal Standby mode

3.1Test result

Test date	N/A	Power Consumption (W)	Condition A	Condition B
		(rounded to the 1st decimal place)
			N/A	N/A

1)Condition A : Any condition providing only reactivation function, or providing only a reactivation function and mere indication of enabled reactivation function

2)Condition B : Any condition providing only information or status display, or providing only a combination of reactivation function and information or status display