Samsung RS21FANS INSTALLATION OF THE WATER DISPENSER LINE

CHECK THE WATER LEVEL

INSTALLATION OF THE WATER DISPENSER LINE

Remove any residual matter inside the water supply line after installing filter.

1) Turn on the main water supply & shut-off valve of the water supply line.

ICE WATER

2) Run water through the dispenser until the water runs clear (6~7 minutes). This will clean the water supply system and clear air from the lines.

3) Additional flushing may be required in some households.

4) Open the refrigerator door and check if water leaks around the water filter.

• A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser. NOTE • Before reinstalling the water filter, remove the wine self (RS2666/2777).

Check the amount of water supplied to the ice tray.

1) Lift up (①) and pull out (➁) the ice maker bucket in the freezer.

2)When you press the test button, the ice cube container is filled with water from the water supply tap.

Check the amount of water (see the illustration below). If the water level is too low,

the ice cubes will be small.

This is not a problem with the ice maker but of the water pressure in the pipe, and occurs frequently. When this problem occurs, contact

the dealer service center to check the amount of water supplied.

ICE MAKER

TEST BUTTON

TOO HIGH

OPTIMUM

LEVEL

TOO LOW