How to use OSD Menu
•FENCE
This is to detect if a moving object passes through the specified LINE or AREA.
In a condition where a moving object is detected in an analysis of the previous and current frames whose movement overlaps a certain area, the system displays “PASS” if the object’s center line passes through the line while it displays “ENTER” or “EXIT” if the center point passes through the area.
| FENCE |
|
|
|
|
LINE |
| OFF |
AREA |
| OFF |
You can set the position and detection direction of the LINE, and the size and position of the AREA.
- How to set the line
| LINE |
|
|
|
|
|
|
| |
PIXEL LEVEL | [4] |
|
| |
|
| |||
<POINT> |
|
|
|
|
DIRECTION |
|
| ||
|
| |||
①If you press the SETUP switch with the LINE option set to ON, you can specify the position and detection direction of the line.
②If you change the PIXEL LEVEL for setting
the position, specify the pixel that moves by a single pressure of the switch.
③In <POINT>, you can specify the first position of the line by pressing the SETUP switch once, and
the second position by pressing the switch again. Use the switch to specify the position.
Set each position of the two points and press the SETUP switch to complete the positioning.
④If you change the DIRECTION, you can specify the detection direction. The detection direction based on the defined two points will be displayed on the screen.