basic recording
Basic procedures to record a video or photo image are described below and on the following pages.
RECORDING VIDEOS
This camcorder features two Recording start/stop buttons. One is on the rear side of the camcorder, the other is on the LCD screen. Select the one that works best for you.
PRECHECK!
• Open the LCD screen and press the Power (
•Set the appropriate storage media. page 30
•Select the Record (
1. Select a subject to record. | 0:00:00 [475Min] | |
• Adjust the LCD panel to the best angle for recording. | ||
9999 1.6M |
•Use the Zoom lever or Zoom button to adjust the size of the subject. page 39
2.Press the Recording start/stop button.
•The recording () indicator appears, and recording starts.
3.To stop recording, press the Recording start/stop button again.
•If power is interrupted or an error occurs during recording, the video may not be recorded/edited.
•Samsung is not responsible for any damage occurred by a failure of normal recording or playback operation because of memory card error.
•Note that damaged data cannot be recovered.
•For
•Eject the battery pack when you have fi nished recording to prevent unnecessary battery power consumption.
•For various functions available when you record videos. page 45
•During recording, some button operations are unavailable. (MODE button, MENU button, etc.)
•Sound is recorded from the internal stereo microphone on the
•Before recording an important video, make sure to test the recording function to check if there is any problem with the audio and video recording.
•Do not operate the Power (
•LCD screen brightness and colour can be adjusted from the menu. Adjusting the brightness or colour of the LCD screen does not affect the image to be recorded. page 86
•This camcorder provides one combined video and photo record mode.
You can easily record videos or photos in the same mode without having to change it.
•You cannot use a locked memory card for recording. You will see a message saying recording is disabled due to the lock.
•You can switch the play mode to the record mode by pressing the Recording start/stop or MODE button.
•If the power cable/battery is disconnected or recording is disabled during recording, the system is switched to the data
recovery mode. While data is being recovered, no other function is enabled. After data recovery, the system will be | 5 |
switched to the STBY mode. When the recording time is short, the data recovery might fail. |