Samsung SP-L300 SPL300WVX/EN, SPL300WVX/XT, SPL300WX/EN, SPL300WX/XY Eco, Usage, Reset, Normal, Bright, 1)Logo, 2)Blue, 1)Auto, 3)Black, Lamp Mode, 2)RGB(PC), 3)RGB(AV), V-Keystone, Background, Crosshatch, Video Type

4)Rear-Ceiling : Vertically Reversed Image

Lamp Mode Used to set the image brightness by adjusting the amount of light generated by the lamp.

1)Eco : This mode is optimized for small screens smaller than 100 inches.

This mode decreases the lamp brightness and power consumption in order to extend the lamp lifetime and reduce noise and power consumption.

2)Normal : This mode is optimized for general use. This mode is the recommended mode for a stable lamp brightness that enables a low-noise, comfortable operating environment even under bright ambient illumination.

3)Bright : This mode maximizes the lamp brightness when the ambient illumination is bright. As the brightness of the lamp increases, the lamp lifetime can be reduced and the noise and power consumption may increase.

V-KeystoneIf video scences are distorted or tilted, you can compensate for this using the vertical Keystone function.

Background You can set the Background that is displayed when there is no signal from the external device connected to the projector.If a signal is received, the Background you set disappears and a normal screen is displayed.

1)Logo2)Blue3)Black

Test Pattern Generated by the projector itself. Utilized as standard to optimize the installation of the projector.

1)Crosshatch : You can check whether the picture is distorted or not.

2)Screen Size : You can refer to picture format sizes such as 1.33:1 or 1.78:1.

Video Type If the screen quality is abnormal since the projector does not identify the input signal type automatically in PC or HDMI mode, you can set the input signal type by force.

▶In [PC] mode, this is only enabled if the input signal is AV Timing(D-Sub).However, for a separate H/V sync., this is only enabled for the 1280 x 720p 59.94 Hz/60 Hz signals.

▶In [HDMI] mode, this is only enabled for the 640x480p 59.94Hz/60 Hz, 1280x720p 59.94Hz/60 Hz signals from among the AV Timing(HDMI) signals.

1)Auto2)RGB(PC)3)RGB(AV)4)YPbPr(AV)

	Usage	Color,	PC menu and
		Sharpness,Tint	zoom
RGB(PC)	When connecting the RGB output of a	Disable	Enable
	PC to the D-Sub terminal
	When connecting the RGB output of
RGB(AV)	an AV device (STB, DVD, etc…) to the	Enable	Enable
	D-Sub terminal
	When connecting the YPbPr output of
YPbPr(AV)	an AV device (STB, DVD, etc…) to the	Enable	Disable
	D-Sub terminal
PC	When connecting a PC to the HDMI	Disable	Enable
	terminal
AV	When connecting an AV device (STB,	Enable	Disable
	DVD, etc…) to the HDMI terminal
Auto	Auto settings	-	-

Eco

Normal

Bright

Crosshatch

Screen

Size

Reset	Using this function, you can reset various settings to the factory default settings.
	1) Factory Default : Changes the settings to the factory defaults.	Factory
		Default