1. Manuals
  2. Brands
  3. Computer Equipment
  4. Projector
  5. Samsung
  6. Computer Equipment
  7. Projector

Samsung SP-L300 SPL300WVX/EN, SPL300WVX/XT, SPL300WX/EN, SPL300WX/XY Contact SAMSUNG WORLDWIDE, Lamp Replacement Procedure, Type 1 (Model Code : SPL300WX/**), Replacing and Cleaning the Filter

1 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39
Download on canonical page 39 pages, 2.39 Mb
Contains Mercury, Dispose According to Local, State or Federal LawsLamp Replacement Procedure

Since the lamp is a high temperature and high voltage product, wait at least one hour from the time that the power cord is disconnected before replacing it.

The lamp is located on the left side of the projector (when looking from the front).

Since the lamp type varies depending on the model code of a purchased product, make sure to check the model code when buying a lamp.

When replacing the lamp, check the model code of a purchased product first and refer to the appropriate replacement instructions.

The model code can be found on the label that is attached to the bottom or rear of the package box or product.

Type 1 (Model Code : SPL300WX/**)

Remove the screw shown in the figure below and than open the cover.

Remove the two (2) screws shown in the figure below.

Hold and pull the lamp handle out of the projector, as shown in the figure below.

Type 2 (Model Code : SPL300WVX/**)

Remove the screw shown in the figure below and than open the cover.

Remove the two (2) screws shown in the figure below.

Hold and pull the lamp handle out of the projector, as shown in the figure below.

Assembling a new lamp is in the reverse order of the disassembly.

Replacing and Cleaning the FilterPrecautions when replacing the projector filter

The filter is located at the bottom of the projector.

Turn off the power of the projector, and then disconnect the power cord after the heat of the projector is cooled sufficiently.

Otherwise, its parts may be damaged due to internal heat. When replacing the filter, dust may occur.

For inquiries on filter purchase, please refer to 'Contact SAMSUNG WORLDWIDE'.

The sequence for replacing or cleaning the filter of the projector.

Turn off the power of the projector, and then disconnect the power cord after the heat of the projector has cooled sufficiently.

Place the product so that its bottom

Replace or clean the filter.

looks upward, and than push and

 

remove the filter cover in the

 

direction of the arrow.

 

*When placing the product with the bottom upwards, make sure to place a soft cloth on the floor to prevent scratches.

MENU

Models

Contents