Installation
A B
Installation
20 English
1.Connect the ends of the water supply hoses to the hot (B) and cold (A) faucets.
2.Tighten the fittings by hand until they are snug, and then tighten them an additional
When you fasten the fittings, do not fasten them too tightly or apply tape or sealant to the faucets or water supply intakes. This can damage the fittings.
After you have connected the water supply hoses to the faucets, ensure that they are connected correctly by pulling the water supply hoses downwards.
3.Place the unconnected ends of the hoses into a bucket and open the faucets connected to the two water supply hoses for 10 or 15 seconds to remove any foreign substances from the hoses. Close the faucets before continuing.
|
|
|
|
2015/7/25 16:55:29 | |||
|
|
|
|