217
LS9-16/32 Owner’s Manual
20
Other functions
5When you have finished making settings,
move the cursor to the OK button and press
the [ENTER] key.
The changes will be finalized, and the popup window
will close.
If you select the CANCEL button or the × symbol
instead of the OK button, your changes will be dis-
carded and the popup window will close.
Here you can specify the contrast and brightness of the display, the brightness of the top panel
LEDs, and the brightness of the lamp connected to the rear panel LAMP connector.
1In the DISPLAY ACCESS section, press the
[SETUP] key to access the MISC SETUP
screen.
1CONTRAST field
BBRIGHTNESS field
2Move the cursor to a knob of the CON-
TRAST/BRIGHTNESS field, and use the dial
or the [DEC]/[INC] keys to set the following
parameters.
●CONTRAST field
• SCREEN knob
........Specifies the contrast of the display
backlight.
●BRIGHTNESS field
• SCREEN knob
........Specifies the brightness of the display
backlight.
•PANEL knob
........Adjusts the brightness of the top panel
LEDs. If a Yamaha AD8HR is connected
to an I/O card that provides a REMOTE
connector, the brightness of the
AD8HR’s LEDs will also change.
• LAMP knob (LS9-32 only)
........Adjusts the brightness of the lamp con-
nected to the rear panel LAMP jack.
Specifying the brightness or contrast of the display, LEDs,
and lamps
LS9-32
1 2
•You can also adjust the contrast by holding down the [HOME]
key and turning the dial.
HINT
Setting the network address • Specifying the brightness or contrast of the display, LEDs, and lamps