Troy-Bilt TB4000 manual

Contents

Main Introduction THANK YOU Contents of Carton PRODUCT REFERENCES, ILLUSTRATIONS AND SPECIFICATIONS Table of Contents Service Information SERVICE INFORMATION WARNING: Identification Numbers SYMBOL MEANING Safety IMPORTANT SAFETY INFORMATION READ ALL INSTRUCTIONS BEFORE OPERATING SAFETY WARNINGS FOR GAS TRIMMERS WHILE OPERATING WHILE OPERATING WITH CUTTING BLADE AFTER USE OTHER SAFETY WARNINGS Push primer bulb, fully and slowly, 5 to 7 times. SAVE THESE INSTRUCTIONS SAFETY AND INTERNATIONAL SYMBOLS SYMBOL MEANING SAFETY ALERT SYMBOL WARNING - READ OPERATOR'S MANUAL FOR SERVICE INFORMATION, CALL: Page Section 2 Know Your Unit Section 3 Assembly INSTALLING AND ADJUSTING THE J-HANDLE INSTALLING THE HARNESS Always use the shoulder harness when using the cutting blade to avoid serious personal injury. REMOVING AND INSTALLING CUTTING ATTACHMENT SHIELD REMOVE THE CUTTING ATTACHMENT AND INSTALL THE CUTTING BLADE To avoid serious personal injury, always wear gloves while handling or installing the blade. REMOVE THE CUTTING BLADE AND INSTALL THE CUTTING ATTACHMENT To avoid serious personal injury, always wear gloves while handling or installing the blade. Section 4 Oil and Fuel RECOMMENDED OIL TYPE RECOMMENDED FUEL TYPE STARTING INSTRUCTIONS Oil and Fuel (continued) Operation FUELING UNIT Section 5 STOPPING INSTRUCTIONS HOLDING THE TRIMMER ADJUSTING TRIMMING LINE LENGTH TIPS FOR BEST TRIMMING RESULTS DECORATIVE TRIMMING USING THE CUTTING BLADE Section 6 Maintenance MAINTENANCE SCHEDULE MAINTENANCE NEEDED WHEN GO TO: Single Line Installation Membrane Line Installation INSTALLING A PREWOUND REEL CHECKING THE OIL LEVEL CHANGING THE OIL Wear gloves to prevent injury when handling the unit. AIR FILTER MAINTENANCE CARBURETOR ADJUSTMENT ROCKER ARM CLEARANCE REPLACING THE SPARK PLUG Do not sand blast, scrape, or clean electrodes. Grit in the engine could damage the cylinder. ACCESSORIES/REPLACEMENT PARTS CLEANING STORAGE LONG TERM STORAGE TRANSPORTING Troubleshooting CUTTING ATTACHMENT WILL NOT ADVANCE LINE ENGINE LACKS POWER OR STALLS WHEN CUTTING ENGINE WILL NOT START ENGINE WILL NOT IDLE ENGINE WILL NOT ACCELERATE Specifications ENGINE DRIVE SHAFT & CUTTING ATTACHMENT Section 9 Warranty CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS OWNER'S WARRANTY RESPONSIBILITIES: MANUFACTURER'S WARRANTY COVERAGE: MANUFACTURERS LIMITED WARRANTY FOR: MTD Southwest Inc 550 N. 54th Street Chandler, AZ 85226 U.S.A.