Operation (continued)
Stop/Off (O)
|
| On/Off Stop |
|
| Control |
Fig. |
| Start/On (I) |
|
| |
PARTIAL (B) | RUN (C) | Primer Bulb |
FULL |
|
|
Choke (A) |
|
|
Choke |
|
|
Lever |
|
|
Fig. |
|
|
5.Fully press and release the primer bulb slowly 5 to 7 times. Gasoline should be felt and visible in the bulb (Fig.
6.Squeeze the throttle control to the wide open (full throttle) position.
7.With the unit in the starting position (Fig.
the starter rope briskly 5 times in the FULL choke (A) position. If the engine attempts to run before the fifth pull, proceed to step 8.
8.Move the choke lever to the PARTIAL (B) position (Fig.
NOTE: The engine will not run in the FULL choke
(A) position.
9.Pull the starter rope 1 to 3 pulls until the engine starts. Run for
10.Move the choke lever to the RUN (C) position and run at full throttle for 30 seconds.
11.Release the throttle control to the idle position and begin operation.
NOTE: f the engine does not start using these procedures, repeat steps 5 through 11 using TWO
(2) pulls in the FULL choke (A) position.
Starter
Rope
Fig. | Throttle |
Control | |
|
|
Engine Re-Start - Warm Engine With Fuel
1.Put the On/Off Stop Control in the START [I] position (Fig.
2.Move the choke lever to the PARTIAL (B) position (Fig.
3.Squeeze the throttle control to the wide open (full throttle) position.
4.With the unit in the starting position (Fig.
5.When the engine starts, move the choke lever to
the RUN (C) position, and run at full throttle for 30 seconds.
NOTE: If the engine does not start using the Engine
NOTE:
STOPPING INSTRUCTIONS
1.Release your hand from the throttle control (Fig.
2.To stop the engine, put the On/Off Stop Control in the STOP [O] position (Fig.
15