Maintenance (continued)
For Use with | For Use with Membrane |
Single Line ONLY | Line or Single Line |
Slotted
Holes
Fig. |
Loop |
Fig. |
Fig. |
Loop |
Fig. |
Fig. | Holding Slots |
5.Check the indexing teeth on the inner reel and outer spool for wear (Fig.
NOTE: Membrane line can only be used with the inner reel with the slotted holes. Single line can be used on either type of inner reel. Use figure
NOTE: Always use the correct line length when installing trimming line on the unit. The line may not release properly if the line is too long.
Single Line Installation
Go To Step 8 for Membrane Line Installation
6.Take approximately 40 feet (12.2 m) of new trim- ming line, loop it into two equal lengths. Insert each end of the line through one of the two holes in the inner reel (Fig.
7.Wind the lines in tight even layers, onto the reel (Fig.
Membrane Line Installation
8.Take approximately 20 feet (6.1 m) of new trimming line. Insert one end of the line through one of the two holes in the inner reel (Fig.
9.Insert the end of the line into the open hole in the inner reel and pull the line tight to make the loop as small as possible (Fig.
10.Before winding, split the line back about 6 inches.
11.Wind the line in tight even layers in the direction indicated on the inner reel.
NOTE: Failure to wind the line in the direction indi- cated will cause the cutting attachment to operate incorrectly.
12.Insert the ends of the line into the two holding slots (Fig.
13.Insert the ends of the line through the eyelets in the outer spool and place inner reel with spring inside the outer spool (Fig.
NOTE: The spring must be assembled on the inner reel before reassembling the cutting attachment.
14.Hold the inner reel in place and install the Bump Knob by turning counterclockwise.
Tighten securely.
19