
When you are looking for an unknown code, you can automatically search through all the codes (AutoSearch).
Note: Because you can assign every device (DVD, satellite) to the VCR, DVD - buttons, you first have to enter a
1.Turn the device you want to operate on.
2.Press SETUP (9) and keep this button pressed until one of the mode LEDs stays lit. Release the SETUP button.
3.Press the Mode button (2) of the device you want to operate. The LED will flash once.
4.Press Prog+ (6) once. After a few seconds the remote control will begin to search for the code (quick search, 1 code per second) When the device reacts, press Prog+ (6) to slow down the search (1 code per 3 seconds). You can go back with Prog- (6) (or forward with Prog+ (6)) if you went too far. When the appliance reacts, press
Note: If certain functions on your appliance do npt work, try the next code for your brand. The search function will begin after the last confirmed code. If that was 030, the search function will begin at 031, and will continue until the last possible code.
4.4 Manually searching for codesNote: Because you can assign every device (DVD, satellite) to the VCR, DVD, AUDIO, SAT buttons, you first have to enter a
1.Turn the device you want to operate on.
2.Press SETUP (9) and keep this button pressed until one of the mode LEDs stays lit. Release the SETUP button.
3.Press the Mode button (2) of the device you want to operate and then release it.
4.Press the Prog+ (6) until it changes channel. If you went past the correct code, use Prog- (6) to go back to the correct code.
5.Press
Note: If your appliance does not have Prog+ button, you can use the PLAY (video or DVD) (20) or On/Off button (1).
Note: If certain functions on your device do not work, you have to try the next code for your brand. The search function will begin after the last confirmed code. If that was 030, the search function will begin at 031, and will continue until the last possible code.
8 | MARMITEK - NICOSHOP |