Epson PowerLite 7900p Projector

Setting Up the Network

Connect each projector you want to monitor to your network and configure it with an appropriate IP address.

1.Connect the projector to your network using a commercially available 100baseTX or 10baseT network cable. Plug the cable into the projector’s Ethernet port.

Ethernet port

To network port

2.Turn on the projector.

3.Press the Menu button on the remote control and select

Network from the Advanced2 menu.

Video

Brightness Control : High

Low

 

 

 

 

 

Audio

Projector ID

: 1

Set

 

 

 

 

Select

Effect

Network

Set

 

 

 

 

 

 

 

 

Setting

COM Port

: RS-232C

USB

 

Network

User'ssLLogo

 

Auto setup

: ON

OFF

 

 

 

 

Advanced1

 

BNC Sync Termination :

ON

OFF

 

 

 

 

Advanced2

Reset

Execute

 

 

About

 

 

 

 

 

 

 

 

Reset All

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

[ ]: Select [ ]: Enter

 

 

 

[Menu]: Exit

 

 

4.If your network assigns addresses automatically, turn on

DHCP.

5.If your network does not assign addresses automatically, turn off DHCP and enter the projector’s IP Address,

Subnet Mask, and Gateway Address, as needed.

❏To enter numbers using the remote control, press the Num button until it lights, then use the numeric keypad.

Zero

Num button

❏To change the network addresses from the projector’s control panel, press the right and left arrow buttons to select the part of the address you want to enter, then use the up and down arrow buttons to increase or decrease the numeric value.

Increase or decrease the value

Select the part of the address to change

Note: If you’re a network administrator, you can use the SNMP option to enter a trap IP address. This lets you receive trap alerts for the projectors you’re monitoring. If you have HP OpenView, a plug-in is available to allow you to manage your projectors in HP OpenView. Check with your dealer or Epson.

When you finish changing an address in the network menu, press the Enter button (on the remote control) or the

Auto/Enter button (on the projector). This stores the value.

6.When you’re done making all necessary changes, press ESC to exit the menu system.

Opening and Closing EMP Monitor

To start EMP Monitor, click Start > Programs or All

Programs > Epson Projector > EMP Monitor.

If you’ve added the program to the Startup programs folder, it may already be open. If so, click the icon in the system tray on the lower-right corner of your screen to display the EMP Monitor window:

Click here to start EMP Monitor

To close EMP Monitor, right-click the program icon shown above, then select Exit.

9/04

Epson PowerLite 7900p Projector - 15