Epson PowerLite 7900p Projector

Using EMP NetworkManager

You can use EMP NetworkManager to configure the projector to send out messages by e-mail, notifying you when a problem occurs with the projector. Before running EMP NetworkManager, make sure you’ve installed the software as described in the User’s Guide. Then follow the steps below to create e-mail settings for each projector you want to monitor.

Selecting the Projectors to Monitor

1.To start EMP NetworkManager, click Start > Programs or All Programs > EPSON Projector > EMP NetworkManager.

You see the EMP NetworkManager screen. The projectors you’ve registered through EMP Monitor appear as icons.

2.If you’d like to register a projector manually and you know

its IP address, double-click the Proj(ector) address selection icon.

You see this screen:

Setting a Password

You can set a password to restrict access to each projector from EMP NetworkManager:

1.Right-click the icon of the projector whose password you want to set, then select Change Password.

2. Enter a password up to 14 characters in length.

Creating the E-Mail Settings

1.If EMP NetworkManager is not already running, open it from the Start menu. You see your registered projectors:

2.Double-click the icon for the projector whose e-mail settings you want to create. Enter your password, if you created one.

3.EMP NetworkManager connects to the projector, and you see this screen:

3.Enter the projector’s IP address and click Add. The projector’s icon is added to the EMP NetworkManager screen.

Note: The projector must be plugged in (projecting or in standby mode) for you to be able to connect to it.

To access a projector in standby mode, you must first select Network ON as the Standby Mode setting in the projector’s Advanced1 menu. (See the User’s Guide for instructions.)

18 - Epson PowerLite 7900p Projector

9/04