![](/images/new-backgrounds/1111637/11163721x1.webp)
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool off and unplug the tool from its electrical outlet before adjusting tool or installing accessories.
To prevent serious injury from flying Fragments: Do not use blades made from
Installing a Saw Blade
Application | Blade | No. of | Type of | ||
Description | Teeth | Cut | |||
| |||||
Fine Trim | Precision Trim | 60 | ~ 100 | Very smooth, | |
Molding | Carbide |
|
| splinter free | |
Trim, Framing, | Combination, | 24 | ~ 60 | Smooth, fast | |
Pressure |
|
| cut | ||
Treated Decking |
|
|
|
| |
Aluminum | 60 | ~ 80 | - - - - | ||
| metal cutting |
|
|
|
1.Use only a
The saw blade speed rating must be at least 5000 RPM. Refer to the above table for saw blade applications and types.
2.Unplug the Circular Saw Line Cord (62) from the electrical outlet.
3.Raise the Blade Guard (20) as far as possible. See photo on the next page.
4.Hold the Blade Guard up and press the
Spindle Lock Button with one hand.
Rotate the Saw Blade until the Spindle
Lock catches and the blade stops.
5.Using the supplied Saw Blade Hex Wrench in the other hand, loosen
(clockwise) the
Screw (42). Remove the Saw Blade Hex Screw (42), Blade Pressure Plate (12), then the Saw Blade.
6.Clean out Blade Cover (11) of any debris.
7.Place the new Saw Blade over the Spindle (16) hole.
The Saw Blade teeth at the bottom of the saw blade should be pointing toward the back of the Circular Saw.
Blade | Blade | |
Pressure | ||
Cover | ||
Plate (12) | ||
(11) | ||
|
Hex
Screw
(42)
Blade Guard (20)
8.Place the Blade Pressure Plate (12) over the Spindle hole, then insert the Hex Screw (42).
9.Press the Spindle Lock Button with one hand, and tighten the Blade Screw (clockwise) using the Hex Wrench with the other hand.
10.
SKU 94245 | For technical questions, please call | Page 11 |