or clamp a straight edge to the material to guide the saw on a straight path. Refer to photo above.
6.Place the saw Base Plate on the material to be cut. Align the front notch (right edge aligns with saw blade) on the cut line.
7.Hold the Circular Saw by both handles.
Always keep hands and fingers away from the Saw Blade.
8.Push in and hold the Switch Lock Button, then squeeze the Switch (61) Trigger with the index finger. Do this before the saw blade touches the material.
9.With the saw at full speed, move the saw slowly forward to complete the cut.
10.When the cut is complete, release the Trigger. Do not set the saw down until the blade stops turning.
11.To prevent accidents, turn off the tool and disconnect its power supply after use. Clean, then store the tool indoors out of children’s reach.
6.When the Base Plate is resting flat on the stock being cut, proceed cutting in a forward direction to the end of the cut.
7.When the cut is complete, release the Trigger and wait for the Saw Blade to come to a stop before lifting the saw out of the cut.
8.If necessary, complete the cut from the opposite direction in the same manner described above.
WARNING! Never pull the saw backwards since the Saw Blade will climb out of the cut and kickback will occur.
9.When the cut is complete, release the Trigger. Do not set the saw down until the blade stops turning.
10.To prevent accidents, turn off the tool and disconnect its power supply after use. Clean, then store the tool indoors out of children’s reach.
Pocket Cuts
1.Tilt the saw forward with the cutting guide notch of the Base Plate on the line drawn for the cut.
2.Raise the Blade Guard (20) with the
Blade Guard Lever (35).
3.With the Saw Blade just above the material to be cut, start the saw and allow the Saw Blade to come to full speed.
4.Gradually lower the Saw Blade onto the stock using the front end of the Base Plate as a pivot point.
5.When the cutting begins, release the Blade Guard.
SKU 94245 | For technical questions, please call | Page 13 |
