![](/images/new-backgrounds/1108509/10850959x1.webp)
30CHAPTER 3: SETTING UP FOR MANAGEMENT
Preparing for Once your Switch’s initial set up is complete you can set up your chosen Management management method as described in “Methods of Managing a Switch”
on page 39.
For detailed information about the specific web interface operations and command line interface commands and problem solving, refer to the “SuperStack 3 Switch Management Interface Reference Guide” on the
Initial Switch Setup Before you begin the initial setup of your Switch, you must first determine your preferred setup method. There are two setup methods:
■Manual Setup — You have two choices of how to configure the IP information, as shown in Table 9.
■Automatic Setup — Your Switch must be online, that is, connected to a network. You have two choices of how to view the allocated IP information, as shown in Table 9.
Table 9 Initial Switch Setup Methods
Manual Setup | Automatic Setup | ||
|
|
|
|
Connecting to a front panel | Use the web interface to | Using 3Com Network | Use 3Com Network |
port | manually enter IP | Supervisor | Supervisor to detect the |
| information by accessing |
| automatically allocated IP |
| the Switch using its default |
| information. |
| IP address |
|
|
| 169.254.100.100. |
|
|
|
|
|
|
Connecting to the console | Use the command line | Connecting to the console | Use the command line |
port | interface to manually enter | port | interface to view the |
| IP information. |
| automatically allocated IP |
|
|
| information. |
|
|
|
|