INSTALLATION
INTERMOUNT III MOUNTING RINGS
The Kappa 60.7cs is packaged with two different speaker adaptor rings. The rings will allow the speakers to be installed into various factory 6,"
Figure 3. Mounting the 65.7cs in a 165mm speaker location using the supplied metal ring.
FLUSH-MOUNT
Figure 5A. Mounting the tweeter using the
3
1 2
SURFACE-MOUNT
Figure 5B. Mounting the tweeter using the
TWEETER ANGLE
Figure 6. Aim the tweeter at the listening position by sliding the stud in the groove on the back of the tweeter cup and rotating the entire assembly in the mounting surface. Lock the tweeter in place, using the small retaining screw.
3
ROTATE ENTIRE ASSEMBLY
TO AIM ANGLED TWEETER
TOWARD LISTENER.
1
SLIDE SCREW UP OR
DOWN TO ADJUST
TWEETER ANGLE.
2
TIGHTEN SCREW TO
LOCK ANGLE SETTINGS.
4
Figure 7A. Behind grille panel.
Figure 7B. Mounted to surface behind grille panel.
FOAM GASKET
MOUNTING RING
Figure 4. Mounting the 60.7cs woofer in a standard speaker location.
1
ATTACH BASE
WITH SCREWS,THEN:
2
3
BLACK
RED (+)
SECURELY TIGHTEN
THE LARGE HAND NUT.
Figures 7A through 7D. The Starfish™ tweeter mount is intended to be used when the tweeter will be installed behind a factory grille (e.g., replacing the factory tweeter behind a door panel). The Starfish will allow you to mount the component tweeter directly to the panel itself or to the area behind the panel. The six mounting tabs can be removed easily to create a number of custom configurations.
Note: Check screw clearance before installing. Use glue if clearance is an issue.
Note: Not all possible mounting configurations are shown.
Figure 7C. Mounted to grille panel.
Figure 7D.
FOAM GASKET | kappa series |
|