3Com Router 5000 and Router 6000 Family Release Notes v2.41 • Page 8
2.3 Software Issues Resolved from v2.20
The following issues have been resolved since the v2.20 release of this software.
• Changing the speed and duplex on the Gigabit Ethernet Module does not take effect
without resetting the interface manually. A manual “shutdown” and then “undo
shutdown” is required to have the changes take effect.
• Loopback LED remains lit solid after remote side sends the loop down code. No Loopback
LED indicator
• Banners edited offline in the proper format will be discarded when loaded into the system
via ftp/tftp
• D4, D4/AMI and ones density are not supported.
• FDL AT&T payload option issues.
• No fdl-att-plb-up and fdl-att-plb-down are available.
• Alarm LED — No Alarm LED indicator
• BERT issues — Bits received since test started and Bits received since latest sync do not
match on a perfect loop
• NAT display issues — NAT sessions do not display “NO-PAT”
2.4 User Documentation Issues resolved From v2.20
The following user Documentation issues have been resolved since the v2.20 release of this
software.
• ACL numbering scheme is different from those documented in the Command Reference
Manual. Use the following corrected numbering scheme:
1000-1099 (Interface-based ACL)
2000-2099 (Basic ACL)
3000-3099 (Advanced ACL)
4000-4999 (Ethernet Frame Header ACL)
• The Command Reference manual states that “reset ike sa” will clear both phase 1 and
phase 2 security associations. ”Reset ike sa” will only clear phase 1 security associations;
”reset ipsec sa” will clear phase 2 security associations.
• MPLS LDP loop detect cannot be configured after LDP is enabled on interface. An error is
reported. Enable LDP loop detect under system view before enabling LDP on the interface.
• The ”virtualbaudrate” command is non-existent in the Command Index. Use the
”virtualbaudrate” command in the Command Line Interface (CLI).
[XXXX-3-Serial2/0/4]virtualbaudrate?
300 only for async mode
600 only for async mode
1200 for syn & asyn mode
2400 for syn & asyn mode
4800 for syn & asyn mode
9600 for syn & asyn mode
19200 for syn & asyn mode
38400 for syn & asyn mode
56000 only for syn mode
57600 for syn & asyn mode
64000 only for syn mode
72000 only for syn mode