3Com 5000, 6000 3. Known Issues for Router 5000 and Router 6000 Release v2.41

3Com Router 5000 and Router 6000 Family Release Notes v2.41 • Page 9

115200 for syn & asyn mode

128000 only for syn mode

384000 only for syn mode

2048000 only for syn mode

The following issues have been resolved since the last release, v2.21, of this software.

• If the user cut and pastes within the BootRom menu to fill in fields (such as filenames for

TFTP downloads) the display will only show a maximum of 8 characters. If the filename is

longer it will be accepted by the system, but will not display characters beyond the initial 8.

• The “more” command truncates large config files(>17KB) on the 5012 routers. If the file

needing to be read is not the saved configuration, transfer the file to a PC disk, and read it

from there. If it is the saved configuration, read it with the “display saved-configuration”

command.

• Display ft1 will display the same statistics multiple times, once for each Frame Relay

interface/sub-interface configured.

• The current IMA aggregate baud rate does not change when links are added or removed,

when using the display interface command. This is a display problem only.

• The Gigabit Ethernet module does not support half duplex mode at 100 Mb setting.

• Display fr pvc statistics do not account for the outbound packets.

• The bridge <x> mac-address command for setting a static MAC entry for a gigabit Ethernet

interface is not supported.

• The bridge <x> mac-address <xxxx-xxxx-xxxx> permit interface command is not an option

for a Gigabit type interface. This command is not supported for Gigabit interfaces.

• CRC and PAD errors on the 1-Port ADSL Module interfere with even the lowest traffic loads,

of expected normal operation — Example 256K traffic on 8Mb link.

• PIM is not supported over an IPsec tunnel. PIM hellos are rejected over an IPSec Tunnel.

• The first IKE peer with local-address defined will have its address be used for all IKE peers in

the policy.

• ATM VBR service classes will fail to be set at Peak Cell Rates higher than 124492 kbps (for

OC3-ATM), 41923 kbps (for T3-ATM) and 33340 kbps (for E3-ATM).

User Documentation issues resolved since the last release, v2.21, of this software.

• Named access list is documented but not supported.

• Name based ACLs, as listed in the command reference manual, are not supported.

3. Known Issues for Router 5000 and Router 6000 Release v2.41

• The router does not allow configuring of an FTP server with Radius Authentication None

option. FTP Anonymous login is not supported. A username and password is required for FTP

access.

• The FTP server does not support filenames containing spaces. 3Com recommends using

underscores instead of spaces as separation delimiters.