CHAPTER 5: ASSIGNING THE V6000 IP

ADDRESS

To assign an IP address to the V6000, use one of the following methods:

ƒHTTP using a Web browser (see Assigning an IP Address Using HTTP)

ƒThe embedded Command Line Interface (CLI) accessed via Telnet or RS-232 (see Assign an IP Address Using the CLI)

ƒBootP or DHCP (refer to the V6000 User Manual)

Record and retain the IP address and subnet mask you assign the V6000.

The default networking parameters are show in Table 2.

Use the ‘Reset’ button at any time to restore the V6000 networking parameters to their factory default values (see Restoring Networking Parameters to the Initial State).

Table 2 V6000 Default Networking Parameters

Parameter

Default Value

 

 

IP Address

10.1.10.10

 

 

Subnet Mask

255.255.0.0

 

 

Default Gateway IP Address

0.0.0.0

 

 

Assigning an IP Address Using HTTP

To assign an IP address using HTTP, follow these 8 steps:

1Disconnect the V6000 from the network and reconnect it to your PC using one of the following two methods:

ƒUse a standard Ethernet cable to connect the network interface on your PC to a port on a network hub / switch. Use a second standard Ethernet cable to connect the V6000 to another port on the same network hub / switch.

ƒUse an Ethernet cross-over cable to directly connect the network interface on your PC to the V6000.

16V6000 Analog Integrated Branch Office Solution Installation Guide V6000 Analog Integrated Branch Office Sol