3Com 900-0387-01 Restoring Networking Parameters to the Initial State

Restoring Networking Parameters to the Initial State

You can use the ‘Reset’ button to restore the V6000 networking parameters to their factory default values (described in Table 2) and to reset the username and password.

The V6000 returns to the software version burned in flash. This process also restores the V6000 parameters to their factory settings. Therefore, you must load your previously backed-up ini file, or the default ini file (received with the software kit) to set them to their correct values.

To restore networking parameters to their initial state, follow these 3 steps:

1Press in the ‘Reset’ button uninterruptedly for a duration of more than six seconds; the gateway is restored to its factory settings (username: ‘Admin’, password: ‘Admin’).

2Assign the V6000 IP address (see Chapter 5: Assigning the V6000 IP Address).

3Load your previously backed-up ini file, or the default ini file (received with the software kit). For information on loading the ini file, refer to the V6000 User Manual.

V6000 Analog Integrated Branch Office Solution Installation Guide 19