3Com B-446, B-406, B-506 operation manual Prepare the CHAR-BROILER for USE, Element Assembly

PREPARE THE CHAR-BROILER FOR USE

When using the broiler for the first time, wipe the entire unit with a clean damp cloth or sponge and mild detergent. Rinse thoroughly clean water. Dry with a soft clean cloth.

Remove the GRATE and raise the

ELEMENT ASSEMBLY.

Install the DRIP PAN and add 2” (5cm) of tap water.

Release the ELEMENT SUPPORT
ROD by lifting the element assembly
slightly, then pulling the lower portion
	Fig. 4 ELEMENT SUPPORT ROD
of the support rod forward. Lower the
ELEMENT ASSEMBLY gently.

CAUTION:

Hot Surface

Exposed surfaces can be hot to the touch and may cause burns.

IMPORTANT: DO NOT attempt to raise the element assembly without first removing the grate. Damage to the hinges will result. Such damage is NOT covered by warranty.

IMPORTANT: Allow drip pan to cool before removing from the broiler.

DO NOT operate the broiler

MODEL B-406: Grate must be installed ABOVE elements. Install the GRATE, front edge first. The TANGS of the grate go DOWN and point toward the FRONT. The grooves on the underside of the grate align with the elements. The rear edge of the grate can be lowered until it rests firmly on the elements.

ELEMENT

HANDLE

FRONT

GRATE TANG

Fig. 5 B-40 GRATE INSTALLATION

without the drip pan installed. DO NOT operate the broiler without 2” (5cm) of water in the drip pan.

IMPORTANT: DO NOT attempt to lower the element assembly without first releasing the support rod. Damage to the hinges will result. Such damage is NOT covered by warranty.

162 303673 OpManual for Built-In Electric Charbroilers

MODELS B-446 and B-506: Grate(s)

can be installed above or below the elements. ABOVE: Gently lower grate over elements. The end with flush tabs goes toward the front. BELOW: Install one wing bolt in each tab. The notch in the wing

rests on the lip of the drip pan. The end with flush tabs must go toward

the front Adjust the wing bolts so that , when the element assembly is lowered, the top of the element is 1/4" (6mm) below the top of the

grate fins.

Fig. 6 B-44 and B-50 GRATE INSTALLATION

7