ASSEMBLY
FIGURE 3
Step 5. Slide PEDAL BUSHING (8) onto SHAFTS of PEDALS (9 RIGHT and 10 LEFT) as shown.
Step 6. Thread SHAFTS of PEDALS (9 & 10) into CRANK (11) until tight, then back off 1/2 turn.
Step 7. Thread PEDAL LOCK NUT (12) onto end of SHAFT. Hold SHAFT with (additional wrench) and tighten PEDAL LOCK NUT with other wrench until tight.
NOTE: PEDAL BUSHING (8) must be able to spin freely after tightening.
11
CRANK
8
PEDAL
BUSHING
9
RIGHT PEDAL
| 12 | |
SHAFT | PEDAL | |
LOCK NUT | ||
|
FIGURE 3
13
SEAT
WASHER
NUT
14
SEAT
POST
15
LOCKING
KNOB
PULL
FIGURE 4
Step 8. Turn LOCKING KNOB (15) counterclockwise to loosen.
Step 9. Pull LOCKING KNOB (15) out and raise SEAT POST (14) to desired SEAT (13) height and release LOCKING KNOB so that it snaps into hole in SEAT POST then turn clockwise until tight.
IMPORTANT
LOCKING KNOB MUST be locked tightly
before you sit on the SEAT.
Step 10. Remove NUTS and WASHERS from SEAT (13) and attach SEAT to SEAT POST (14) with NUTS and WASHERS.
FIGURE 4
6
