TRSM Installation | 5 |
To remove the faceplate:
1Unscrew the securing screws on the module’s faceplate. See Figure 1.
Captivescrews
Blankfaceplates
LMM+ininslot11
Figure 1 LANplex 6004 with Blank Faceplates
Read if replacing a TRSM
2Pull the faceplate away from the system.
You can replace a module while the system is powered on. Replacing the module requires that you remove the attached cables from the module’s ports prior to installing the new module.
NOTE: Ensure that there is a record of where the cables are attached so that you can correctly
CAUTION: Inserting and extracting a TRSM erases all information stored in NVRAM on the TRSM. Before removing the installed TRSM, save all nonvolatile data using the NV data save functionality on the system’s Administration Console. This information can be restored using the NV restore functionality. See the LANplex 6000 Administration Console User Guide for information on saving, restoring, and resetting nonvolatile data. Inserting and extracting a module will cause a warm system reboot.
To remove a module:
1Discharge yourself of static electricity by placing the ESD wrist strap on your wrist and clipping the alligator clip to the mounting screw located next to the black ground symbol on the system’s right mounting bracket. See Figure 3. If your system does not have mounting brackets, touch the rear panel.
2Disconnect the cables from the module’s ports.
3Unscrew the securing screws on the module’s faceplate. See Figure 1.
