Choosing a Site
Choosing a Site
Introduction | This section describes how to choose a site for the PathBuilder S21x switch. |
Choosing a Site Choose a site within an appropriate distance of a power source. The selected site should be free of accumulated dust and environmental extremes.
Caution
All PathBuilder S200 series switch products should be used in environments designed for computers and electronic equipment. In areas susceptible to lightning, take precautions to prevent damage to electronic equipment. Contact your telephone company or an electronic accessories vendor for information on lightning protection equipment. If you experience problems caused by surges from lightning, install appropriately rated surge suppressors on power and data lines connected to your PathBuilder S200 series switch.
Mise en Garde
Tous les produits PathBuilder S200 series switch doivent être utilisés dans des environnements conçus pour les ordinateurs et équipements électroniques. Dans les zones sujettes à la foudre, prenez soin de protéger l’équipement électronique contre tout dommage. Contactez votre compagnie de téléphone ou un vendeur d’accessoires électroniques pour de plus amples informations sur les équipements de protection contre la foudre. Si vous avez des problèmes engendrés par des surtensions dues à la foudre, installez des protections contre les surintensités appropriées sur les lignes d’alimentation et de données connectées à votre produit PathBuilder S200 series switch.
Vorsicht
Alle PathBuilder S200 Series
Power Source Depending on your application and the country in which the PathBuilder S21x switch will operate, a power source must be a grounded 100 to 240 VAC outlet.
Cable Clearance/ Allow at least 12 inches (30.5 cm) in back of the unit for interfacing cable clearance
Air Circulation and air circulation, as shown in Figure
Installing the PathBuilder S21x Switch Hardware |