Powerup Diagnostics
Power Up | When the PathBuilder S21x switch power cord is plugged into the power supply | ||
Sequence | outlet, you will see the following powerup sequence: | ||
|
|
|
|
| Stage | when... | ...this indicates |
|
|
|
|
| 1 | POWER (GREEN) lights | PathBuilder S200 series switch is |
|
| turns on. | receiving power. |
|
|
|
|
| 2 | TEST (GREEN) comes on | Diagnostics executes for 30 seconds. |
|
| and blinks five times |
|
|
|
|
|
| 3 | STATUS (GREEN) comes on | Indicates software is being downloaded |
|
| and blinks at slow rate. | from FLASH. |
|
| TEST/WATCHDOG |
|
|
| (ORANGE) light also remain |
|
|
| on. |
|
|
|
|
|
| 4 | STATUS (GREEN) light | Software is initializing your system |
|
| stays off for up to 10 seconds, | configuration. |
|
| then turns green. |
|
|
|
|
|
Hardware Failure If the TEST light turns on and remains on, one or more of the diagnostic tests have failed, indicating there is a hardware problem. Contact 3Com for possible repairs to your PathBuilder S21x switch.
Diagnostic Failure If the TEST light does not blink at all, but the Status light is on, the diagnostic software image is corrupted. Perform a download of the software option bundle.
Powerup Failure If the STATUS light blinks continuously, at a constant rate, the software bundle in Flash memory is corrupted. Perform a cold load of the software option bundle. See the Software Installation and Coldloading Manual (Part No. T0028) for more information.
Powering on the PathBuilder S21x Switch |
