3D Connexion MB DMX Universal DMX Control:, Mounting:, MB DMX™, MB DMX™, MB DMX™, MB DMX™, Mounting, Operation, Operation, Breaker Reset

MB DMX™

Operation

tors on the rear of the units. Remember the Male XLR connector is the input and the Female XLR connector is the output. The first unit in the chain (master) will use the female XLR connector only. The last unit in the chain will use the male XLR connector only.

For longer cable runs we suggest a terminator at the last fixture.

2.Select a MB DMX to be the “master” unit. Locate the dipswitches on the side of the unit and flip dipswitch 10 to the “on” position.

3.Follow the chart on page 14 to select a desired rotation speed and direction. Be sure to note that this selection will be universal throughout all motors in the chain.

4.For all other motors in the chain (slaves) located the dipswitches on the side of the units and be sure dipswitch 10 is in the “off” position.

5.Connect main power to all the motors and they will immediately begin to rotate to the presets of the “master” unit.

6.The optional MINI/C Blackout Controller may be used with this function for to stop motor rotation.

Universal DMX Control: This function allows you to use a universal DMX-512 controller such as the American DJ® DMX Operator™ or Show Designer.™ to control rotation speed, rotation direction, and the built-in power sockets (usually for lamps). Operating through a DMX controller allows you the freedom to create unique and customized programs tailored to your specific individual needs.

1.The MB DMX™ uses two DMX channels. Channel one controls power sockets located on the side of the unit. Channel two control the motor’s rotation speed and direction.

2.To control your motor in DMX mode, follow the set-up procedures on pages 7 - 9 as well as the set-up specifications that are included with your DMX controller.

3.Use the DMX controller’s faders to control the various DMX fixture traits. A list of the traits is located on page 13.

4.This will allow you to create your own programs.

5.When using a DMX controller and setting up for DMX operation follow the DMX addressing procedure in your controller’s manual. All fixtures must follow a specific DMX addressing protocol for proper operation in DMX mode.

6.For help operating in DMX operation consult the manual included

MB DMX™

Operation

with your DMX controller.

7.For longer cable runs (more than a 100 feet) use a terminator on the last fixture.

MB DMX™

Mounting

Mounting: The MB DMX™ ships with a built-in rigging point and two large holes in the base of the unit (that are to be used for safety cables). The rigging point is located on the bottom of the unit. This rigging point is secured to the fixture by two large Phillips screws. When the rigging point is not to be used and when the fixture is shipped from the manufacture, the point is shipped inverted (inside the bottom of the unit). When the fixture is to be hung by truss or other means, please use the rigging point and secure the fixture with safety cables. Always be sure to firmly secure the rigging point to the unit. The MB DMX ™ is to mounted in bottom-up position to a ceiling or may hung from truss using a C-Clamp rated at 50 pounds or greater.

MB DMX™

Breaker Reset

This unit is equipped with a built-in safety breaker. This breaker is designed to close the power circuit in the event of an internal short or power surge. This will reduce the risk of electrical shock or fire and protect the circuitry. To reset the breaker, push the breaker button in until you hear it “pop” back in to place. If the breaker continues to pop, stop using the unit and contact our customer support team, the unit may need to be returned for service.