MB DMX™ | DMX Traits |
The chart below details the DMX traits in depth. The individual trait can only be accessed by using an universal DMX controller. Note: “Lamp” in channel 1 refers to the two power sockets located on the side of the motor (these sockets are intended to be used with lamps to light up the mirror ball).
CHANNE L 1 |
|
|
| C HANNE L 2 | ||||
|
| |||||||
LAMP | MO TO R SPE E D | |||||||
255 |
|
| 255 | |||||
255 |
|
|
|
| 255 |
|
| CCW Speed 5rpm - 255 |
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
Lamp O n 129- 255
129 |
|
| 129 |
| CCW Speed 0. | 5rpm - 129 | |
|
| Stop |
| ||||
|
|
| 128 |
|
| ||
128 |
|
|
|
|
| ||
|
|
|
| ||||
|
|
| 127 |
| CW Speed 0.5rpm - 127 | ||
|
| ||||||
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
Lamp O ff
01C W Speed 5rpm - 01
00 |
|
| 00 |
|
| Stop |
|
|
| ||||
|
| 00 | ||||
00 |
|
| ||||
MB DMX™ | Dipswitch Settings |
The charts below details the Master/Slave setting for Master/Slave configuration. Use this configuration when you will be using two or more fixtures in a Master/Slave configuration. Note: The “Master” settings should only be used once at the first motor, using the “master” setting more than once in the chain may result in erratic operation.
Dipswitch Function Settings
Dipswitches 1 ~ 8 Used to change the rotation speed during
Master Motor Speed List
Switch | DIP1 | DIP2 | DIP3 | DIP4 | DIP5 | DIP6 | DIP7 | DIP8 |
Speed | ||||||||
SPEED1 (0.5 rpm) | ON | - | - | - | - | - | - | - |
SPEED2 (1 rpm) | OFF | ON | - | - | - | - | - | - |
SPEED3 (1.5 rpm) | OFF | OFF | ON | - | - | - | - | - |
SPEED4 (2 rpm) | OFF | OFF | OFF | ON | - | - | - | - |
SPEED5 (2.5 rpm) | OFF | OFF | OFF | OFF | ON | - | - | - |
SPEED6 (3 rpm) | OFF | OFF | OFF | OFF | OFF | ON | - | - |
SPEED7 (4 rpm) | OFF | OFF | OFF | OFF | OFF | OFF | ON | - |
SPEED8 (5rpm) | OFF | OFF | OFF | OFF | OFF | OFF | OFF | ON |
" - " = Dip Switch Off
Dipswitch 9 Control Rotation Direction;
On = CW Rotation / Off = CCW Rotation
Dipswitch 10 Controls Master/Slave Operation;
On = Master / Off = Slave
Note: Dipswitch 10 must be in the off postion for DMX operation
The optional MINI/C may be used during Master/Slave operation to stop motor rotation and to blackout the electrical sockets
©American DJ® - www.americandj.com - MB DMX™ Instruction Manual Page 13 | ©American DJ® - www.americandj.com - MB DMX™ Instruction Manual Page 14 |