3M SCP725 - page 34

Operator’s Guide 3M™ Super Close Projection System SCP725

ENGLISH

4. Install the lamp taking care to seat it fully into the lamp socket connection and tighten the lamp retaining

screws.

5. Replace the lamp door and secure it with the retaining screws.

6. Verify the projector operates correctly. Plug in power cord and press the standby button to power on projector.

Note: If the lamp door is not installed correctly, the projector will not power on.

ENGLISH

Contents

Main Page Contents Introduction Safety Information Contents of Shipping Box Product Description Page Introduction Thank You for Choosing 3M Equipment Trademarks Important Notice Warranty; Limited Remedy; Limited Liability Page Product Patents Regulatory Notices Page Safety Information Intended Use m WARNING m CAUTION Page Contents of Shipping Box 1 2 3 4 5 Product Description Machine Characteristics Dimensions Page Parts Identification Projector Terminal Connections I/O Module Control Panel (optional accessory) Top Terminal Panel on I/O Module Bottom Terminal Panel on I/O Module 19 Operators Guide 3M Super Close Projection System SCP725 3M 2011. All Rights Reserved. ENGLISH Remote Control Functions Page Operating Instructions Projector Start Up Stand By Mode Menu Navigation Main Menu Input Menu Picture Menu Advanced Picture Menu Audio Menu Setup Menu Advanced Setup Menu Information Menu Machine Specifications Maintenance Hg Lamp Replacement Page Page Page Troubleshooting Identifying an Expired Lamp Module I/O Module Troubleshooting Projector Troubleshooting Page Page Projector Indicator Lights I/O Module Indicator Lights Replacement Parts and Accessories Replacement Parts Optional Accessories (not shown)