8e6 Technologies manual Configuring the R3000 for Authentication, Configuration procedures

CHAPTER 1: INTRODUCTION AUTHENTICATION OPERATIONS

Configuring the R3000 for Authentication

Configuration procedures

When configuring the R3000 server for authentication, settings must be made in System and Group windows in the Administrator console.

NOTES: If the network has more than one domain, the first one you add should be the domain on which the R3000 resides.

The entries described in this section represent entries to be made on a typical network.

System section

The first settings for authentication must be made in the System section of the Administrator console in the following windows: Operation Mode, LAN Settings, Enable/Disable Authentication, Authentication Settings, Authentication SSL Certificate (if Web-based authentication will be used), and Block Page Authentication.

1.Select “Mode” from the control panel, and then select “Operation Mode” from the pop-up menu.

The entries made in the Operation Mode window will vary depending on whether you will be using the invisible mode, or the router or firewall mode.

In the Listening Device frame, set the Listening Device to “eth0”.

In the Block Page Device frame:

•If using the invisible mode, select “eth1”.

•If using the router or firewall mode, select “eth0”.

2.Select “Network” from the control panel, and then select “LAN Settings” from the pop-up menu.

54 8E6 TECHNOLOGIES, R3000 ENTERPRISE FILTER AUTHENTICATION USER GUIDE