A&D HL-3000LWP, HL-3000WP, HL-300WP Preparation, Installing Batteries / Connecting The AC adapter

New six batteries (R6P/ LR6/ AA size)

Close the rubber cap

PREPARATION

Installing Batteries / Connecting The AC adapter

Installing Batteries

CAUTION

When replacing batteries, be careful not to apply too much force to the weighing pan. An excessive force could damage the scale.

Remove the battery cover and insert six batteries (R6P / LR6 / AA size) into the battery compartment, taking extreme care to that the polarities plus and minus are observed. Be sure to lock the battery cover again after installing the batteries.

AC adapter (optional)

CAUTION

Battery cover lock

Optional AC Adapter

When using an AC adapter, the scale does not comply with the IP65.

The AC input requirement could be 100, 120, 220, 230 or 240 volts (50/60Hz) depending on the area where used, so please verify that the adapter is correct.

Plug the AC adapter to the AC adapter socket inside the battery compartment.

Attach the battery cover and fit the
rubber cap.	AC Adapter jack

Setting up the HL-WP

CAUTION

Avoid installing the scale in direct sunlight, as that may cause discoloration or a malfunction. Place your HL-WP on a firm weighing table so that the scale is level. (The scale will not perform accurately when it is not level.)

Place the scale on the firm surface and adjust the feet so that the sprit level shows the scale is level for an accurate weighing.

3