ADMP / ADM / ADMR
Electrical diagram ADMR
TERMINAL STRIP CONNECTIONS
|
|
| Earth |
|
|
| |
N | Neutral | ||
L1 | Phase input of controller | ||
L2 | Phase input of program- | ||
|
|
| controlled pump |
L3 | Phase input of continuous pump | ||
L4 | Phase input of extra error signal | ||
L5 | Phase input of flue damper | ||
|
|
| motor |
L6 | Phase output of flue damper | ||
|
|
| motor (feedback) |
L7 | Phase input of isolating | ||
|
|
| transformer (primary side) |
L8 | Phase output of isolating | ||
|
|
| transformer (secondary side) |
COMPONENTS | |||
A | Controller | ||
B | Gas control | ||
C | Glow igniter | ||
D | Ionisation rod | ||
E | Extra error signal | ||
F | |||
G | |||
H | Continuous pump | ||
J | Flue damper | ||
K | Isolating transformer | ||
L | I/0 switch control | ||
M | Display/Flat cable | ||
N | Extra ON mode switch | ||
O | Connector for the flue gas sensor | ||
P | Temperature sensor | ||
|
|
| (T2 - bottom of tank) |
Q | Temperature sensor | ||
|
|
| (T1 - top of tank) |
R | Selection resistor | ||
CONTROLLER CONNECTIONS | |||
J1 | Connector for display to controller | ||
J2 | Connector for power supply to | ||
|
|
| controller |
J19 | Connector for extra error signal | ||
|
|
| and power supply to flue damper |
J20 | Connector for gas control | ||
J21 | Connector for program- | ||
|
|
| controlled pump |
J29 | Connector for feedback from flue | ||
|
|
| damper |
JP2 | Connector for ionisation rod and | ||
|
|
| glow igniter |
JP3 | Connector for temperature | ||
|
|
| sensor T2 |
JP4 | Connector for flue gas sensor | ||
JP5 | Connector for temperature | ||
|
|
| sensor T1 |
JP6 | Connector for selection resistor | ||
|
|
| and feedback from |
JP8 | Connector for extra ON mode | ||
|
|
| switch |
F1 | Fuse | ||
F2 | Fuse | ||
subject to change INT/0808/ADMR/01 | and conditions apply, please refer to our website. |
Data | Terms |
www.aosmithinternational.com
