Sherborne Wood & Multifuel Stoves 17
INSTALLATION
FIREBOX LINER PANELS
The Sherborne Wood and Multifuel stoves use
reflective liners to the sides and back. The throat
plate sits on top of the side and rear panels. These
should come fitted to your fire, if however they are
not proceed as follows to fit them.
•Remove the front fuel bars.
•Set the small liners into the back of the fire.
•Insert side liner panels
•Fit the throat plate with the single bend and two
cut outs to the front facing up. The projecting lugs
sit on top of the side liners. The long centre tab on
the back edge rests on the rear liners. The shorter
turn-down tabs against the vertical face.
•Replace the front fuel retainer bars.
Note: Neither the rear firebox liners nor the side
firebox liners are "handed", both faces are
suitable for direct contact with the fire.
Note: Cracking of lining panels does not effect
efficiency.
Fig. 11 Sherborne Medium Multifuel liners
and throat plate.
Fig. 12 Liners inserted in Sherborne
Medium Multifuel.
Fig. 13 Inserting Throat Plate in to
Sherborne Medium Multifuel.
Fig. 14 Liners, throat plate and grate in
Sherborne Medium multifuel.
REMOVALOF THE THROAT PLATE
Blocked chimneys cause dangerous fumes to
escape. Remove throat plate at least monthly to
clean. Keep chimney and flue ways clear.