Aarrow Fires Sherborne Wood & Multifuel Stoves MULTIFUELGRATE

MULTIFUELGRATE

The grates in the Sherborne Multifuel units

comprise a series of reciprocating cast iron bars

seated on a pivoted "comb". All bars in the grate are

identical, but every other bar is turned through 180

degrees, with the ends of the bars marked "H" sit-

ting on the high sections of the comb, and the ends

marked "L" sitting on the low sections.

To assemble the grate, fit bars to low sections of the

comb first, inserting end marked "H" into rear

channel with groove on underside of bar located on

upstand tab, and then lowering end marked "L"

onto the low section of the comb. The upper bar is

fitted in a similar manner, but with the end marked

"L" inserted in the rear channel, and the end

marked "H" seated on the high section of the comb.

After extended use it may be necessary to replace

some of the grate bars. Periodic inspection of the

bars is recommended and the removal of any nails

or wire that may be present after burning wood.

All the grate bars in each appliance are identical

and can easily be lifted out after removal of the fuel

retainers. Remove damaged grate bars and replace

with casting of the same type, fitting as per

instruction above. (Check Identification letters on

the casting when reordering).

18 Sherborne Wood & Multifuel Stoves

INSTALLATION