ASSEMBLY INSTRUCTIONS
1.Locate the baseplate, cap nuts and washers.
2.Place the antenna on top of the baseplate, aligning the holes in the antenna base with the studs on the baseplate. Make sure that the power supply wire is in the channels of the antenna base and is not crushed between the antenna
base and the baseplate.
3.Attach the washers and cap nuts to the bolts on the baseplate. DO NOT TIGHTEN.
4.Again make sure that the power wire is not crushed between the antenna base and baseplate and tighten the cap nuts with a ½” wrench.
5.Connect the wire on the power supply to the power wire connected to the antenna. The wires will only connect in one direction.
abcoffice | 2 |
www.abcoffice.com |