2.4.2 Front Panel Switches & Indicators Headers

This header is used for connecting switches and LED indicators on the chassis front panel.

Watch the power LED pin position and orientation. The mark “+” align to the pin in the figure below stands for positive polarity for the LED connection. Please pay attention to connect these headers. A wrong orientation will only cause the LED not lighting, but a wrong connection of the switches could cause system malfunction.

Hardware Setup

HLED (Pin 1, 3):

Connects to the HDD LED cable of chassis front panel.

RST (Pin 5, 7):

Connects to the Reset Switch cable of chassis front panel.

SPKR (Pin 13, 15, 17, 19):

Connects to the System Speaker cable of chassis.

SLED (Pin 2, 4):

Connects to the Suspend LED cable (if there is one) of chassis front panel.

PWR (Pin 6, 8):

Connects to the Power Switch cable of chassis front panel.

PLED (Pin 16, 18, 20):

Connects to the Power LED cable of chassis front panel.

2-7

Page 17
Image 17
Abit AN9 32X manual Front Panel Switches & Indicators Headers