ARAID 1500, ARAID 2000 User’s Manual
Changing Single Mode to Default Mode
Performing a Manual
When you change the operation mode switch from Single to Default, the target (lower bay) drive will be automatically rebuilt with the contents from the source drive (upper bay).
LCD messages are shown below.
◎Change mode from Single to Default
Note: Do not remove either drive while the disk rebuild is in progress, to avoid data loss.
Booting the system with one hard drive in default mode
(1)ARAID can boot the system with one hard drive from either drive.
LCD message when the source drive is in the upper bay:
LCD message when source disk is on the lower bay:
(2)When both drives are installed, ARAID will automatically detect the source disk (primary HDD) and boot the system. When source disk fails, ARAID will automatically boot the system from target disk (secondary HDD). The message displayed on the LCD is shown below.
LCD message with both disks installed on ARAID
13
Accordance Systems Inc.
