Novell NetWare
21
Configuration Settings
This section describes the configuration settings which can be altered in your Print
Server. To make changes, use PSCONFIG or the programs described in Chapter 8 -
Management Tools.

Configuration using PSCONFIG

To use PSCONFIG to change the device settings, the procedure is as follows.
1. Run PSCONFIG; a list of Print Server units will appear.
2. Select the Print Server you want to setup, then press [ENTER].
3. Select Change Configuration. A list of category configurations will appear.
4. Select the category you want to edit, then press [ENTER].
5. Select the item you want to edit and press [Enter]. If you are prompted to enter a
character string, enter a string.
6. Change any other items you wish. The [ESC] key will return you to main menu to
select another category if you wish.
7. Select Execute Change and press [ENTER] to save the configuration changes to
the Print Server.

General Device Settings

The following configuration changes can be made, regardless of which Network
protocol or operating systems is being used. :
• Get Print Server Information
• Reset Print Server
• Restore Default Configuration
• Change the Print Server’s name.
• Change the device password.
• Disable/Enable network protocols.
• Get Printer Status (idle, off-line, printing)
• Logical Printer Setup (see page 24)
• Define logical printer
• Set pre-print-job string.
• Set post-print-job string
• Serial port configuration (if exists):
• Baud rate
• Handshake protocol
• Stop bits
• Data bits
• Parity.