Quick Installation Guide
Mounting Switches in a Rack
Please comply with the following instructions to ensure that your switch is securely mounted in the rack.
1.Use a standard EIA
2. Use the brackets and screws supplied in the rack mounting kit.
3. Use a
4. Position the switch in the rack by lining up the holes in the attached brackets with the appropriate holes on the rack, and then use the
Installing a Management Module
One Management Module is required to manage all of the switches in the stack. A Management Module only installs in a switch’s
You can install a Management Module as described below:
1.Disconnect power to the switch (the modules are not
2.Remove the face plate on the switch’s upper slot by removing the two screws with a
3.Before opening the package that contains the module, touch the bag to the switch casing to discharge any potential static electricity.
4.Remove the module from the
5.Holding the module level, gently push it all the way into the slot along the guide rails, ensuring that it firmly engages with the connector.
6.If you are sure the module is properly mated with the connector, tighten the retainer screws to secure the module in the slot.
Caution: The
Installing Optional Media and Stacking Modules
The two lower slots on the rear panel of the switch are provided for various optional media expansion modules
4
