Installing the Mylex Disk Array Controller as the Primary NetWare 5.0 Controller
NetWare scans for controllers that do not have drivers already loaded.
6.At the “Select a driver” box, press <Ins> to choose to install an unlisted driver.
7.Insert the NT4/NW Drivers Software Kit diskette into the diskette drive.
8.Press <F3> to specify the path of the NetWare driver you’re about to install.
9.Change the path line to read:
A:\netware
and press <Enter>. NetWare scans for drivers on the floppy diskette in the specified path.
10.In the “Select a driver to install” box, select the appropriate driver for your controller:
MDAC.HAM Mylex Disk Array Controller <model number>
11.Select Yes at the confirmation box to install the driver.
12.Press <Enter> to select the default server boot path.
13.Select No to save a backup of the old or existing driver.
14.Select No to decline selection of an additional driver to install unless you are installing more than one controller at this time.
15.Exit INSTALL.NLM by pressing <Esc> three times, then selecting Yes at the “Exit Install?” box.
This concludes installation of the driver files needed to run your Mylex Disk Array Controller under NetWare 5.0.
PCI Disk Array Controller Drivers Manual |