Insyde MobilePro BIOS POST Beep Code and POST Messages

The POST error message index lists the error message and their possible causes. The most likely cause is listed first.

NOTE: Perform the FRU replacement or actions in the sequence shown in FRU/Action column, if the FRU replacement does not solve the problem, put the original part back in the computer. Do not replace a non-defective FRU.

This index can also help you determine the next possible FRU to be replaced when servicing a computer. If the symptom is not listed, see “Undetermined Problems” on page 73.

The following lists the error messages that the BIOS displays on the screen and the error symptoms classified by function.

NOTE: Most of the error messages occur during POST. Some of them display information about a hardware device, e.g., the amount of memory installed. Others may indicate a problem with a device, such as the way it has been configured.

NOTE: If the system fails after you make changes in the BIOS Setup Utility menus, reset the computer, enter Setup and install Setup defaults or correct the error.

Beep Code

Message

Description

 

 

 

short, short, short; short,

“FAULTY DMA PAGE REGISTERS”

DMA page registers do not function properly.

short, long

 

 

 

 

 

short, short, short; short,

“FAULTY REFRESH CIRCUIT”

RAM refresh circuit does not function properly.

long, short

 

 

 

 

 

short, short, short; short,

“ROM CHECKSUM INCORRECT”

BIOS ROM checksum failed.

long, long

 

 

 

 

 

short, short, short; long,

“CMOS RAM TEST FAILED”

CMOS RAM test failed.

short, short

 

 

 

 

 

short, short, short; long,

“DMA CONTROLLER FAULTY”

DMA controller does not work properly.

short, long

 

 

 

 

 

short, short, short; long, long

“INTERRUPT CONTROLLER

The interrupt controller does not work properly.

short

FAILED”

 

 

 

 

short, short, short; long,

N/A

Keyboard controller failed to respond with the

long, long

 

self-test command.

 

 

short, short, long; short,

N/A

No video device found.

short, short

 

 

 

 

 

short, short, long; short,

N/A

No RAM installed.

short, long

 

 

 

 

 

N/A

“KEYBOARD CONTROLLER

Keyboard controller failed during system inquiry

 

FAILURE”

about connected devices.

 

 

N/A

“KEYBOARD FAILURE”

The keyboard fails to respond or no keyboard is

 

 

connected.

N/A

“CMOS FAILURE - RUN SCU”

CMOS data error, probably due to battery power

 

 

loss.

N/A

“CMOS CHECKSUM INVALID - RUN

CMOS checksum error.

 

SCU”

 

 

 

 

N/A

“RAM ERROR AT LOCATION xxxxxx:

The RAM failed during memory test at the indi-

 

WROTE: xxxx

cated location.

 

READ: xxxx”

 

N/A

“PARITY ERROR AT UNKNOWN

Parity error during memory test at unknown

 

LOCATION”

location.

 

 

N/A

“PARITY ERROR AT LOCATION

Parity error during memory test at the indicated

 

XXXXXX”

location.

 

 

 

Chapter 4

67

Page 75
Image 75
Acer 290E manual Insyde MobilePro Bios Post Beep Code and Post Messages, Beep Code Message Description