92 Chapter 4
Index of Error Messages
Error Message List
Error Messages Check or do the following in sequence:
Stuck Key See “Keyboard or Auxiliary Input Device Check” on page 88.
System CMOS checksum bad - Default
configuration used
TRTC battery.
TRun the BIOS Setup Utility to reconfigure the system time,
then reboot system.
Real time clock error TRTC battery
TRun the BIOS Setup Utility to reconfigure system time, then
reboot system.
TMainboard
Previous boot incomplete - Default
configuration used
TRun “Load Setup Defaults” in BIOS Setup Utility.
TRTC battery
TMainboard
Invalid System Configuration Data TRun “Load Setup Defaults” in BIOS Setup Utility.
TMainboard
Operating system not found TRun the BIOS Setup Utility to check if the fixed disk and drive
A are properly identified.
TCD/DVD-ROM drive
THard disk drive
TMainboard
Power-on indicator turns off and LCD is
blank.
TPower source (battery pack and power adapter.) See “Power
System Check” on page 89.
TEnsure every connector is connected tightly and correctly.
TReconnect the DIMM
TMainboard
Power-on indicator turns on and LCD
is blank.
TPower source (battery pack and power adapter.) See “Power
System Check” on page 89.
TReconnect the LCD connector
THard disk drive
TLCD cable
TLCD inverter board
TLCD
TMainboard
Power-on indicator turns on and LCD
is blank. But you can see POST on an
external CRT.
TReconnect the LCD connectors.
TLCD cable
TLCD inverter board
TLCD
TMainboard
Power-on indicator turns on and a
blinking cursor shown on LCD during
POST.
TEnsure every connector is connected tightly and correctly.
TMainboard
Failure Fixed Disk TReconnect the hard disk drive connector.
TRun “Load Setup Defaults” in BIOS Setup Utility.
THard disk drive
TMainboard