Installation

Figure A-3. Installing the BBU

5.Install the BBU so that J1 on the BBU connects to J5 on the DAC960PG or DAC960PJ. Pin 1 on the BBU’s J1 must connect to hole 1 on the DAC960PG and DAC960PJ’s J5. The mounting holes on the BBU will line up with the mounting holes on the DAC960PG or DAC960PJ if the connectors are plugged in correctly.

6.Be sure the four standoffs line up with the four holes in the DAC960PG or DAC960PJ. Place a nylon screw through a hole from the back of the DAC960PG or DAC960PJ into a standoff, and turn the screw to the right until it is snug (not too tight). Repeat this step with the remaining three standoff screws.

A-4

DAC960PG and DAC960PJ Installation Guide