The following table describes the parameters found in this menu.
Parameter | Description | Options |
Onboard FDC | Select Enabled if your system has a floppy | [Enabled]. [Disabled] |
Controller | disk controller (FDC) installed on the system |
|
| board and you wish to use it. If you install an |
|
|
| |
| drive, select Disabled in this field. |
|
|
|
|
Onboard | Select a logical COM port name and |
|
Serial Port 1 | matching address for the serial port. Select |
|
| an address and corresponding interrupt for |
|
| the serial port. |
|
|
|
|
UR2 Duplex | In an infrared port mode, this field appears. |
|
Mode |
| |
|
| |
| mode permits transmission in one direction |
|
| only at a time. Select the value required by |
|
| the IR device connected to the IR port. |
|
|
|
|
Onboard | Select a logical LPI port address and | [xxx+IRQx] |
Parallel Port | corresponding interrupt for the physical |
|
| parallel port. |
|
|
|
|
Parallel Port | Select an operating mode for the onboard | [Normal], [EPP], |
Mode | parallel (printer) port. | [EPP], [EPP+ECP] |
|
|
|
ECP Mode | This item allows users to manually set the |
|
used DMA | DMA channel for ECP mode |
|
|
|
|
37
