Acer P7200i, P7205, P7203 manual English

English

26

Keystone	Adjust image distortion caused by tilting projection. (±40 degrees)
H Keystone	Press the		or	to adjust image distortion horizontal and makes
	a squarer image.
V Keystone	Press the		or	to adjust image distortion vertical and makes a
	squarer image.
H. Position	•	Press	to move the image left.
(Horizontal	•
position)		Press	to to move the image right.
V. Position	•	Press	to move the image down.
(Vertical position)
	•	Press	to move the image up.
Frequency	"Frequency" changes the projector's refresh rate to match the
	frequency of your computer’s graphics card. If you can see a vertical
	flickering bar in the projected image, use this function to make the
	necessary adjustments.
Tracking	Synchronizes the signal timing of the projector with the graphics card.
	If you experience an unstable or flickering image, use this function to
	correct it.
Sharpeness	Adjusts the sharpness of the image.
	•	Press	to decrease the sharpness.
	•	Press	to increase the sharpness.
PIP	•	Choose "On" to to see two screens at the same time.
	•	Choose "Off" to disable the function.
PIP Source	Press		and	to choose the secondary video source: Composite,
	S-Video or Component signal.
PIP Location	Choose the PIP secondary signal location on the display screen.
PIP Size	Choose the PIP secondary signal size on the display screen.

Note: "H. Position", "V. Position", "Frequency" and "Tracking" functions are not supported under HDMI, DVI or Video mode.

Note: "Sharpness" function is not supported under HDMI, DVI or computer mode.

Note: PIP, PIP source, PIP Location and PIP Size are not supported under Video mode.