Chapter 1
Getting Started
20
CMOS Checksum Error -
Defaults loaded
CMOS checksum error during post
process. Press "F1" to ignore it or
press Ctrl-Alt-Esc to enter cmos
setup utility.
Conflict I/O Ports Conflict in I/O resource settings
detected. Contact your dealer or an
authorized service center.
DISK BOOT FAILURE, INSERT
SYSTEM DISK AND PRESS
ENTER
There is no bootable floppy disk and
hard disks detected. Please insert a
bootable floppy disk into floppy drive.
Floppy disk(s) fail ( ) No floppy disk detected. Set the Halt
On parameter (see page 41) to either
one of the settings except “All Errors”
and “All, but keyboard”. When the
system encounters this error, it will not
show this message.
Keyboard error or no keyboard
present
No Keyboard detected. Set the Halt On
parameter (see page 41) to either one
of the settings except “All Errors” and
“All, but diskette”. When the system
encounters this error, it wil not show
this message.
Memory test fail System detects memory error during
POST. Replace the SDRAM DIMMs or
contact your dealer or an authorized
service center.
Primary IDE channel no 80
conductor cable installed
System displays this message when
you are using a UDMA66 hard disk
with a 40 pins conductor cable.
Primary master hard disk fail Primary master hard disk type
mismatch between user's setting in
STANDARD CMOS SETUP (see page
41) and what BIOS detected during
POST.
Error Message Corrective Action
Ap8400-e.book Page 20 Friday, October 1, 1999 2:20 PM